Skip To Content
Flex Shot

Flex Shot Clear Thick Rubber Adhesive Sealant

8 oz
$18.60 each($2.33 / oz)
Victoria H‑E‑B plus!
6106 N. NAVARRO

Description

Flex Shot Clear Clear Thick Rubber Adhesive Sealant, 8 oz

  • Ingredients

    CONTAINS: DIMETHYLSILOXANE (CAS 70131-67-8), SILICA (CAS 7631-86-9), METHYLTRIACETOXYSILANE (CAS 4253-34-3), ETHYLTRIACETOXYSILANE (CAS 17689-77-9), PETROLEUM DISTILLATES (CAS 64742-46-7), DIFLOUROETHANE (CAS 75-37-6).

    Allergens and safety warnings

    WARNING: CAUSES SKIN IRRITATION. CONTENTS UNDER PRESSURE. CONTAINS FLAMMABLE PROPELLANT. READ REAR PANEL FOR OTHER CAUTIONS! KEEP OUT OF REACH OF CHILDREN. WARNING! UNCURED SEALANT CAUSES IRRITATION ON CONTACT WITH SKIN AND EYES. IN CASE OF CONTACT WITH SKIN, WIPE OFF WITH PAPER TOWELS OF CLOTH AND WASH WITH SOAP AND WATER. IN CASE OF EYE CONTACT, IMMEDIATELY FLUSH WITH WATER FOR 15 MINUTES. CALL A PHYSICIAN IMMEDIATELY. USE WITH ADEQUATE VENTILATION. CONTENTS UNDER PRESSURE. DO NOT PUNCTURE OR INCINERATE. DO NOT REMOVE RUBBER PLUG. DO NOT STORE AT TEMPERATURES ABOVE 120 DEGREES F. DO NOT STORE IN AUTOMOBILES, IN DIRECT SUNLIGHT OR ANY AREA WITH TEMPERATURES ABOVE 120 DEGREES F. KEEP CONTAINER AWAY FROM HEAT, SPARKS AND FLAME. SEE SAFETY DATA SHEET.

  • DIRECTIONS FOR USE: (1) ALL SURFACES MUST BE CLEAN, DRY AND FREE FROM DIRT, GREASE AND OIL. (2) HOLD CAN AT 45 DEGREE ANGLE, PUSH AGAINST THE NOZZLE SIDE AND APPLY INTO THE JOINT OF SEAM TO OBTAIN FULL CONTACT BETWEEN SURFACES. (3) FLEX SHOT CAN BE SMOOTHED WITHIN 5 MINUTES OF APPLICATION. REMOVE EXPRESS IMMEDIATELY WITH A DRY PAPER TOWEL. (4) SEALANT FORM A TACK FREE SKIN IN 20 MINUTES. LENGTH OF DRY TIME DEPENDS UPON TEMPERATURE AND HUMIDITY USUALLY CURE WITHIN 24 TO 48 HOURS. (5) AFTER USING, EXTEND A SMALL AMOUNT OF MATERIAL BEYOND THE END OF THE NOZZLE. THIS WILL CURE AND FORM A SEAL FOR THE REMAINING MATERIAL. PULL OUT THIS CURD PLUG WHEN YOU ARE READY TO USE AGAIN.